Welcome to bObsweep's Support Community!

Mingle, ask questions, and share ideas with your bObsweep family around the world.

New to the community? Start here.

Checkup Test - Junior

If Junior is not performing as well as he used to, you can diagnose the problem with a simple home checkup test.

Put Junior in checkup mode:

  1. Hold down the CHECKUP button on his cover.
  2. While still holding down the CHECKUP button, flip Junior’s power switch ON. Junior will chirp three times to let you know he is now in checkup mode.

While in checkup mode, the bObsweep icon on Junior's screen will blink continuously.

Step One: Edge Sensors

The 4 ovals at the top of Junior’s screen should be lit. These represent his 4 edge sensors.

Lift Junior about 6 inches (15 cm) off the ground. You should see the 4 ovals turn off.

If all 4 ovals turn off while Junior is lifted, place him back on the floor and continue on to the next step.

Step Two: Wall Sensors

To test Junior’s wall sensors, you will need a flat, white surface.

Drag your imitation wall around the front of Junior’s bumper. The 5 ovals at the bottom of his screen should light up one by one. Junior’s rightmost sensor, the one closest to his side brush, is less sensitive than his other sensors.

If all 5 ovals light up, you may move on to the next step of the checkup test.

Step Three: Touch Sensors

Press the left side of Junior’s bumper and the bar at the top left of his screen should light up; press the right side of the bumper and the bar at the top right should light up. Press the center of the bumper and both bars should light up at the same time.

If both bars light up correctly, you may move on to the next step of the checkup test.

Step Four: Charging Station

The charging station must be synced and plugged in for this portion of the checkup test.

Press the GO button on Junior’s cover. Next, place Junior directly in front of his charging station, about 1 foot (30 cm) away.

The 4 battery bars should be lit on his screen.

The far left and far right bars represent the station’s 2 internal sensors. If either one of them fails to light up, then then there is likely an issue with Junior’s charging station. Wipe the window on the front of the station and test the sensors again.

The 2 middle bars represent Junior’s internal sensors. If these fail to light up, clean the black receiver on Junior’s top and the small hole in the center of his bumper.

If all 4 battery bars up correctly, you may move on to the next step of the checkup test.

Step Five: Screen

Press the GO button on Junior’s cover once more. Each icon on his screen should light up in a repeating rotation. You are now testing Junior’s screen.

If every icon on the screen lights up, you may move on to the next step of the checkup test.

Step Six: Brush and Suction Power

Press the WAFFLE button on Junior’s cover.

Both the side brush and the main brush should start rotating and you should feel air flowing from the back of the dustbin.

If Junior’s main brush is having difficulty rotating, he will display on his screen that there is “something funny going on" with his main brush.

If Junior’s vacuum motor is behaving oddly or if his dustbin has been removed, he will indicate that there is “something funny going on” with his dustbin.

Move on to the next step of the checkup test if all parts are working properly.

Step Seven: Wheels

Lift Junior off the floor to keep him from running away. Next, press the MUTE button and his wheels should drive forward.

Press the MUTE button once more. Junior’s wheels should drive backwards.

If Junior is having difficulty rotating either one of his wheels, he will indicate that there is “something funny going on” with them.

Press MUTE again to make him stop.

 

To exit checkup mode, press the CHECKUP button one last time, or flip Junior's power switch OFF so he can rest until his next cleaning session!

 

If Junior encounters any difficulty during his checkup test, contact our support team at support@bobsweep.com or 1-888-549-8847 for support in the US & Canada.

Have more questions? Submit a request