Welcome to bObsweep's Support Community!

Mingle, ask questions, and share ideas with your bObsweep family around the world.

New to the community? Start here.

Replacing Screen - Bob Standard

For this repair, you will need a Phillips head screwdriver and replacement screen.

Make sure Bob’s side power switch is turned OFF and flip him over onto a flat surface. Remove the screw securing Bob’s main brush in place.

Remove Bob’s main brush to access and remove the screw located beneath it (depending on Bob's model, there may be 2 screws).

Remove the 5 screws lining Bob’s underside.

Flip Bob back onto his wheels and lift his cover up. Depending on your Bob's model, you may need to remove 3 or 4 circuit plugs to detach the cover completely. Pinch the small white tab on the side of each circuit plug and pull upwards to remove.

For older versions of Bob, you must remove 3 circuit plugs from the mainboard:

For newer versions of Bob, you must remove 4 circuit plugs from the mainboard:

bottomcovercircuit.jpg

topcovercircuit.jpg

Slide Bob’s power inlet out and place the cover aside.

Remove the 5 screws securing Bob’s circular screen in place.

Lift all of the screen’s pieces out: the cover plate for the buttons, the LCD screen, and, 3 springs.

screen_standard_parts.png

Place the cover plate inside the large circular space on Bob’s cover, and place the 3 springs between the plus signs.

springs.jpg

Lastly, place the LCD screen on top of the springs and replace all 5 screws securing it in place. Make sure to line up the holes on the screen with the screw posts on Bob’s cover. 

Now you’re ready to put Bob’s cover back together. First, reattach all the circuit plugs you removed to

separate Bob's cover. Press down on each circuit plug to ensure it securely locks in place.

For older versions of Bob, reattach 3 circuit plugs to the mainboard:

For newer versions of Bob, reattach 4 circuit plugs to the mainboard:

bottomcovercircuit.jpg

topcovercircuit.jpg

Before closing Bob's cover, slide his power inlet back in its place.

Carefully realign the edges of Bob’s cover and flip him onto his back. Replace the 5 screws on his underside to seal his cover together.

Replace the 1 or 2 screws located beneath Bob's main brush.

Place the main brush back in its compartment. Attach the end piece first

and align the square end with the square-shaped notch inside Bob.

Lastly, replace the screw securing Bob's main brush in place and your repair is complete!

 

Have more questions? Submit a request